Installation Instructions; Unpacking The Machine; Positioning The Glass Polisher; Assembling The Brushes - CPI STEMSHINE Operating Instructions Manual

UNPACKING THE MACHINE

The machine is delivered packed in a cardboard box containing compressed
polystyrene. Dispose of the packing material according to the requirements of the local
recycling laws.
Verify the machine's integrity and in particular the electric cables. If in doubt, ask a technician
to check before proceeding with installation.

POSITIONING THE GLASS POLISHER

 The machine does not require anchoring - but must be level on whatever surface it is
sitting on. This may require the adjustment of the nut located at the base of each leg.
 Make sure that no objects (cloths, etc.) are placed under the glass drier so as not to
obstruct air flow.
 Ensure the glass drier is not placed close to any taps and/or water connections.

ASSEMBLING THE BRUSHES

Each glass polisher is packaged with 8 brushes and these brushes are colour coded (red,
yellow and green) at the bottom of the brush base. On the top of each support (B) is a coloured
dot corresponding to the brush colours (red, yellow and green).
Place each brush on top of support (B) (matching the colours) and slide the brush down the
support. Ensure that slot (A) is connected by slightly rotating the brush in a clockwise
direction. If the brush is not properly fixed on the support, it will not rotate once the machine is
switched on.
CPIGP8AOPINST

INSTALLATION INSTRUCTIONS

Page - 8 SALES + SERVICE
(866) 912-3469
WWW.CPISHINE.COM