3-Thread Rolled Wave Stitch - Baby Lock Acclam BLES4 Instruction And Reference Manual

W

3-Thread Rolled Wave Stitch

A
1. Turn the Wave/Overlock Selector lever from "OVERLOCK" to "WAVE".
V
2 . C ut t h e t h read s f rom
3. Engage the threading lever to threading position. (page 17)
E
4 . P lac e t h e rig h t need le t h read c one on t h e s ec ond s pool pin on lef t .
5. Slip the right needle thread into the telescopic thread guide directly above the thread. Follow the left
need le t h read ing pat h d ow n t o t h e rig h t need le.
6 . T h read t h e rig h t need le us ing t h e need le t h read er. ( pag e 2 0 )
S
7 . P lac e t h e upper looper t h read c one on t h e 2 nd f rom
8. Slip the upper looper thread into the telescopic thread guide directly above the thread. Follow the
T
t op t h read ing pat h f or t h e rig h t need le t h read , d ow n t h e f ront t h read ing pat h , t h roug h t h e c h rom e
thread guide, and directly to the "U" threading port for the upper looper. Thread the upper looper.
I
( pag e 1 8 )
9 . P lac e t h e rig h t need le t h read and upper looper t h read und er t h e pres s er f oot and t o t h e b ac k .
T
10. Place the lower looper thread cone on the first spool pin on right.
11. Thread lower looper using the standard lower looper threading technique. (page17)
C
12. Engage the threading lever to serging position.
13. Set Stitch Selector on "C" for Rolled Wave Stitch.
H
14. Set Stitch Length and Stitch Width following the illustration below.
Note: R ec om m end ed s et t ing s w ill v ary d epend ing on t h read t ype and f ab ric .
NEEDLES
rig h t
L
4 2
t h e t h read c ones , rais e pres s er f oot and rem ov e t h read s f rom
LENGTH
0 . 7 5 - 1 . 5 R
R
rig h t s pool pin.
STITCH
WIDTH
SELECTOR
3 . 0 - 5 . 0
C
t h e t h read pat h s .
WAVE/OVERLOCK
SELECTOR
WAVE