Using The Thread Trimming Function (Jump Stitch Trim) - Baby Lock Solaris 2 Instruction And Reference Manual

MAKING EMBROIDERY ADJUSTMENTS
Using the Thread Trimming
Function (Jump Stitch Trim)
The thread trimming function
automatically trim any excess thread jumps within
the color. This function is initially turned ON. To
turn this function OFF, press
. This function can be turned on or off during
embroidering.
* Your customized setting remains after turning the
machine off and on.
a Jump stitch
Note
• When this function is turned on, use the
included ball point needle 75/11 for
embroidering patterns with short jump
stitches such as alphabet characters. Using
other needles may cause the thread to
break.
a
Press .
102
b
will
key and then
■ Selecting the Trim Function to Adjust
Press to turn off the thread trimming
function.
 The key will display as
* The machine will not trim the thread before moving
to the next stitching.
Jump Stitch Length
When the thread trimming function
on, you can select the length of the jump stitch.
Stitches below the value will not be trimmed. This
function can be turned ON or OFF during
embroidering.
Select a setting from 5 mm to 50 mm in 5 mm
increments.
* Your customized setting remains after turning the
machine off and on.
Press or to select the length of jump stitch.
For example: Press to select 25 mm (1 inch)
and the machine will not trim a jump stitch of 25
mm or less before moving to the next stitching.
Note
• If design has many trims, it is recommended
to select a higher jump stitch trim setting in
order to reduce the amount of excess tails
on backside of fabric.
• The higher number of the jump stitch length
selected, the fewer number of times the
machine will trim. In this case, more jump
stitches remain on the surface of the fabric.
.
is turned