3-Thread Reversed Wave Stitch - Baby Lock Acclam BLES4 Instruction And Reference Manual

3-Thread Reversed Wave Stitch

Y ou c an als o g et t h e w av e s t it c h in t h e b ac k of f ab ric b y c ros s ing t h e upper and low er looper t h read s
before the threading ports. This Reversed Wave Stitch is attractive for an expressive stitch with decorative
cover stitches. (fig. A)
1. Move the Wave/Overlock Selector lever from "OVERLOCK" to"WAVE".
2 . C ut t h e t h read s f rom
t h read s f rom t h e t h read pat h s .
3. Engage the threading lever in threading position, for threading the loopers.
( s ee pag e 1 7 )
4 . P lac e t h e rig h t need le t h read c one on t h e s ec ond s pool pin on lef t .
5. Slip the right needle thread into the telescopic thread guide directly above
the thread. Follow the left needle threading path down to the right nedle.
6 . T h read t h e rig h t need le us ing t h e need le t h read er. ( s ee pag e 2 0 )
7 . P lac e t h e upper looper t h read c one on t h e s ec ond f rom
8. Slip the upper looper thread into the telescopic thread guide directly above the thread. Follow the top
t h read ing pat h f or t h e rig h t need le, d ow n t h e f ront t h read ing pat h , t h roug h t h e c h rom e t h read g uid e, and
directly to the "L" threading port for the lower looper. Thread the lower looper. (page 17)
Note: This upper looper thread which goes into lower looper through "L" threading port appears as wave
s t it c h on t h e b ac k s id e of f ab ric .
9. Place the thread cone on the LOWER LOOPER spool pin.
10. Thread lower looper using standard lower looper threading technique. (Refer to Steps 2 - 5 on page 17)
The only difference regarding standard threading is you use the "U" threading port instead of the "L" port.
1 1 . P lac e t h e rig h t need le t h read and t h e low er looper t h read f rom
pres s er f oot and t o t h e b ac k .
12. Engage the threading lever in the serging position.
13. Set Stitch Selector on "B" for Wave Stitch.
14. Set Stitch Length and Stitch Width following the illustration below.
Note: I t is not rec om m end ed t o us e rev ers ed rolled w av e.
NEEDLES
rig h t
L R
t h e t h read c ones , rais e pres s er f oot and rem ov e
LENGTH WIDTH
0 . 7 5 - 2 . 5 5 . 0
W rong
Side
rig h t s pool pin.
t h e eye of t h e upper looper und er t h e
STITCH WAVE/OVERLOCK
SELECTOP SELECTOR
B
A
R ig h t
Side
WAVE
W
A
V
E
S
T
I
T
C
H
4 3