Omron D41D Manual page 18

D41D
19.Do not tamper the product with a replacement actuator.
Store replacement actuators in a safe place where they cannot be
easily reached.
20.Build a safety system using the outputs of both Safety Outputs 1
and 2. Wiring with only one safety output may lead to loss of the
safety function due to a single failure.
21.Wiring should meet the requirements specified in Section 9.4.3 of
IEC 60204-1 to prevent malfunction due to ground faults in the
safety output lines.
22.Do not wire the product to an input of a safety controller in parallel.
23.Do not try to disassemble, repair, or modify the product. Doing so
may cause loss of the safety function.
24.Do not operate the product in an environment with flammable or
explosive gas.
25.After installation of the product, qualified personnel should verify
to see that the installation, inspection, and maintenance are
properly performed. The qualified personnel should be qualified
and authorized to secure the safety on each phase of design,
installation, running, maintenance and disposal of system.
26.Auxiliary output is NOT a safety output. Do not use the Auxiliary
output individually for any safety function. Such incorrect use
causes loss of the safety function of the product and its relevant
systems.
27.Disconnect the product and the controller connected to the product
from power supply when replacing the product. Failure to do so
may cause unexpected operation of devices connected to the
product.
28. The safety function may not operate normally due to a malfunction
of the wiring, setting, or switch, and the machine may continue to
operate, which may result in personal injury. Make sure that the
safety function works before starting operation.
29.Do not use the product as a door stopper. (The performance of the
product may be degraded due to a collision caused by opening
and closing the guard door.)
18