Table of Contents
Advertisement
Cleaning and care
Cleaning the plinth filter
Pull the handle out of the plinth filter.
Clean the plinth filter thoroughly un-
der running water.
Squeeze the plinth filter very carefully
several times as you rinse it.
Rinse the plinth filter until all visible
residues have been removed.
Use a damp cloth to remove any lint
from the handle.
Damage caused by a damaged
or worn plinth filter.
The heat exchanger will clog up if the
plinth filter is not in good working or-
der. This can cause a fault.
Check the plinth filter following the
instructions provided in "Frequently
Asked Questions – Replacing the
plinth filter". Replace the plinth filter if
necessary.
56
Install the plinth filter back on the
handle. Make sure it is the correct
way round.
Push the plinth filter in completely.
This will push in the right-hand guide
pin at the same time.
Advertisement
Table of Contents
