Table of Contents
Advertisement
EN 10
4.
EM5.2E AA
SCAVEM bracket. Lift the Auto-SCAVEM bracket slightly up,
and at the same time bend the top a little away from the tuner.
Now, push the bracket into the direction of the CRT, and lift it
out of the LSP-bracket.
To get access to the SSB test points, do the following:
1
2
Figure 4-8 SSB removal (part 1)
1. Put the LSP in service position 2 (as described above).
2. Release the two clamps at the top of the SSB bracket (1)
and pull the bracket upward (2) (it hinges in the bracket at
the LOT side).
3. Now you can remove the complete SSB bracket.
1
S S B
2
Figure 4-9 SSB removal (part 2)
1. Push the top of the SSB towards the LOT (1).
2. Due to the pressure, the two metal clamps at both sides of
the SIMM-connector will release (2).
3. Take the complete SSB out (3).
Mechanical Instructions
CL 26532041_067.eps
110402
3
2
CL 26532041_068.eps
110402
2
S S B
1
Figure 4-10 SSB removal (part 3)
1. Once you have taken out the SSB, remove the shieldings
(2). Sometimes it is necessary to unsolder some solder-
tags first (1).
2. Now re-place the SSB module in the SIMM-connector in
reverse order.
Notes:
•
For better access to the SSB, it is possible to order an
"extension tool" under number 9965 000 14526.
•
If necessary for the measurement, you can put the LSP in
"Service position 2" (as described above).
4.4
Assies/Panels Removal
Sometimes, it can be necessary to swap a complete assy or
Printed Wiring Board (PWB). How that can be done is
explained below.
4.4.1
Top Control Assy/Panel
Notes:
•
PV02 styling: assy is mounted in the front cabinet;
•
FL13B styling: assy is mounted in the rear cover.
1. Remove the two fixation screws.
2. Push the assy a little bit upwards, and then pull it
backwards to release it from the front hinge.
3. Lift the panel from its bracket, while releasing the four
fixation clamps.
SAM
SDM
1
CL 26532041_069.eps
110402
Advertisement
Table of Contents
