Setup Flow; Basic Operations Of Menu Screen - Canon RC-IP100 User Manual

Setup Flow

When setting up the system for the first time, or when new
cameras are added, set up in the manner as follows.
Be sure to perform an operation check after the setup.
1 IP address settings
Configure the IP address of the connected device according
to the system configuration.
(A P16 "Network Settings")
2 Camera setup
Set up the connected camera.
(A P15 "Camera Settings Menu")
3 Remote control settings
For configuring the functions to be assigned to the buttons
and knobs of this unit.
(A P9 "Changing an Assigned Function")
Basic Operations of Menu
Screen
1 Tap the [SETTINGS] button on the home screen.
The settings menu appears.
2 Select the item to be configured.
Settings Menu
Video
o
Allows you to switch the video outputs of the connected
cameras on or off.
(A P15 "Switching the Camera Video Output On/Off")
MENU Control
o
Allows you to display and operate the settings menu of the
selected camera.
(A P15 "Camera Settings Menu")
Function
o
Allows you to configure the settings for this unit.
0 Touch Screen Volume
Allows you to configure the operation sound of the operation
panel.
0 Brightness
Allows you to configure the brightness of the operation panel.
0 Power Save
Allows you to configure the duration of time before this unit
enters into power save mode.
Tapping the operation panel while in the Power Save mode
exits the mode.
Power save mode is disabled while the settings menu screen
is displayed.
0 Default Setting
Allows you to restore the default settings of this unit.
Tapping the button changes the button color. Tap the
[ENTER] button in this condition and then turn off the power
to restore the default settings.
0 Default Setting User
Initializes the function that is assigned to a button.
Tapping the button changes the button color. Tapping the
[ENTER] button in this state executes initialization and
displays "Completed". Tap the [Close] button to complete the
configuration.
0 Setting Data<->USB
Allows you to write the settings of this unit to a USB drive and
vice versa.
Connect the USB drive to the SERVICE terminal on the rear
panel of this unit.
Memo :
0 Format the USB drive with FAT32/16 in advance. This unit
does not support formatting.
Network
o
Allows you to configure settings related to the network.
(A P16 "Network Settings on This Controller")
Touch Screen
o
Allows you to calibrate the operation panel.
Tapping the [Touch Screen] button displays the adjustment
screen. Operate according to the on-screen instructions.
Setup Flow
11