Mistral MKM2200 Instruction Manual page 18

How to Use this Machine
The following operating descriptions contain a
diagram of how to work with the appliance. You
will find detailed recipes for individual dishes,
their ingredients, proportions and weight in the
machine recipe database.
a. Install the drive shaft (25) in the bowl and
install the bowl in the housing.
b. Depending on the nature of the food to be
prepared, install the appropriate accessory:S
ATTENTION! The knife blades are very
sharp. Be careful not to get hurt.
c. Put the food to be processed in the bowl.
Do not exceed the maximum volume of the
bowl (max 3000 ml). If you are going to cook
food in the steam basket (7), pour enough
water (broth, stock) into the bowl to cover
the food in the steam basket. When adding
the ingredients to the bowl, it is possible to
dose them precisely thanks to the scales
function (see: "SCALES FUNCTION"). If you will
be preparing dishes from recipes, fill the bowl
according to the instructions for the recipe.
ATTENTION! Do not fill the bowl over the
Max. Level mark on the bowl.
ATTENTION! Be especially careful when
cooking food. Do not run the appliance
with an empty bowl. When cooking
products in the steam basket, take care
of the right amount of water in the bowl.
ATTENTION! When inserting and pouring
the ingredients into the bowl, take
special care not to flood the base of the
appliance. Danger of electrocution.
d. Install the bowl lid (2) on the bowl (8).
e. Connect the appliance to the mains and
then switch it on using the swith (9) on the
left side of the appliance. If you do not take
any action within 5 minutes, the appliance
will go into sleep mode. Restarting is done by
touching the control panel.
f. After starting the machine, select the
appropriate mode from the touch control
panel.
A red dot at the right-bottom of the display
indicates the current operating mode.
Recipes – select the appropriate recipe,
continue with the displayed instructions.
Manual Mode – declare the temperature, time
and speed from the touch panel respectively.
Automatic programmes – select the appropriate
automatic programme, make possible
parameter adjustments.
The selection of the range of a given value can
be made directly on the touch control panel or
by means of the knob (13) after the parameter
has been indicated on the panel. Start the
process by pressing the Start icon . Pressing the
knob will also start or stop the process. The
white light of the knob indicates that the process
is in progress.
ATTENTION! If you have set a
temperature, the speed level can not set
greater than "3".
ATTENTION! If you have declared a
temperature greater than 60°C, do not
set the speed greater than "3". Risk of
burns!
ATTENTION! Do not set the mixing speed
higher than "3" when using the stir
paddle (5).
ATTENTION! Do not set the speed higher
than "4" when working with the whisk.
ATTENTION! Always use kitchen gloves
when cooking or heating the contents
of the bowl, adding ingredients and
emptying it. RISK OF BURNING!!!! g.
Keep an eye on the process, or make
adjustments to settings and quantities
of ingredients after the machine has
stopped working. Smaller ingredients
can be added through the hole in the lid
when the cap is opened (1).
Note: the setting can not be adjusted
during operation. To adjust it, need
Pause or Stop first. After adjust the
setting, press Start to continue.
ATTENTION! If you notice that when
making heavy pulps and doughs, the
machine significantly reduces the speed
or the speed fluctuates, stop the process
immediately. Reduce the amount of
food processed.
18