Mistral MKM2200 Instruction Manual page 16

BOIL:
At boil, after set the temperature, press the Start
icon to start cooking. It will automatically stop
operation after the desired temperature reaches.
FOOD PROCESSOR
1. Install the drive shaft (25) in the bowl and
install the bowl in the housing.
2. Mount the food processor pin(18), disc (17)
and Food processor lid (15) on the rotary shaft.
Make sure to mount the disc with the correct
side up depending on the nature of the
operation (Grate or Slice).
ATTENTION! The grating and slicing disc
is sharp. Be careful not to get hurt!
3. Prepare the food to be processed. Cut the
fruit and vegetables into smaller pieces so that
they pass through the feed hole in the Food
processor lid and remove the stones from
them.
4. Connect the appliance to the mains and then
switch it on using the switch (9) on the left side
of the appliance.
5. When the machine starts up, select the
AUTOMATIC PROGRAMMES mode and then
select the Food processor mode, make
possible time and speed adjustments.
Warning: never set the speed level over
"6" when grating or slicing.
6. After selecting the parameters, start the
process with the Start button. To stop the
process, press the Stop button .
7. Slowly insert the food into the feed hole
in the Food processor lid (15) and press
down on them with the pusher (14). When
working, do not let the bowl fill to the end
with the processed food. Periodically turn off
the appliance and empty the bowl of the
processed food.
ATTENTION: The Food processor lid (15)
is not used to cover the bowl during
cooking with heat and when using the
chop blade and stir paddle.
8. At the end of the programme, turn off the
appliance with the switch (9), disconnect it
from the mains, empty the bowl and clean the
appliance.
CHOP:
Place the chop blade on the drive shaft, place
the food into the bowl and close the bowl lid,
then press the Start icon to start chopping.
TURBO:
Use finger keep pressing the Turbo icon, the
machine will start the operation at speed level
'12".
WEIGH:
How to enter Scale mode.
(1) At Automatic Programmes mode , press
Weigh to enter Scale mode.
(2) At Standby or Pause model, press the Scale
Icon on the left-upper corner of the display to
enter Scale mode.
Scale icon on the corner
The integrated scales allow you to weigh all
ingredients directly in the mixing bowl and in the
Steam Accessory.
Put in the first ingredient and check the
quantity on the display. If you wish to add more
ingredients push the Tare button again and add
the next ingredient. Repeat these steps as often
as required to the maximum weight (5 kg).
Note: the scale works from 5g to 5kg
(max.) with a increments of 5g.
The display provides you with valuable
information when weighing or adding
ingredients. if the ingredients is overload 5200g,
the display shows OVERWEIGHT after weigh, press
End button to exit the Scale mode.
16