Maserati Ghibli 2021 Owner's Manual page 29

operational. For more details see
chapter "Blind Spot Assist - BSA" or
"Active Blind Spot Assist - ABSA"in
section "Driver Assistance Systems".
The external of the rear-view mirror
support is equipped with LEDs, lighting
up when the turn signals and vehicle
entry/exit lights are activated.
When the surround view camera
system is installed, at the external
bottom side of the rear-view mirror
is the side view camera (refer to
"Surround View Camera System" in
section "Driver Assistance Systems").
Mirrors Positioning
The power mirror controls are located
on the driver's door trim panel.
The power mirror controls consist of
mirror select buttons and a four-way
mirror control switch.
To adjust a rearview mirror, press
either the L (left) or R (right) button
to select the mirror that you want to
adjust. The spin button will illuminate
indicating the rearview mirror is
activated and can be adjusted.
Press the mirror control switch
corresponding to the arrow
indicating the direction of the desired
movement.
For optimal vision orientate the
outside(s) mirror(s) in order to frame
Understanding the Vehicle
the adjacent lane and get a partial
overlap with the visible image on the
inside rearview mirror.
Power mirror preselected positions can
be reset by operating the Memory
Driver Seat device. Check "Memorize
the Driver's Seat Position" in this
section for further information.
WARNING!
Vehicles and other objects seen in the
external side convex mirror will look
smaller and farther away than they
really are. Relying too much on your
passenger side convex mirror could
cause you to collide with another
vehicle or object. Use the inside
mirror to judge the size or distance
of a vehicle seen in the external side
convex mirror.
Tilt Side Mirrors In Reverse
This function provides automatic
external rearview mirrors positioning,
allowing the driver to view the ground
area behind the front doors. The
external mirrors will move slightly
downward from the current position
when the shift lever is shifted into
reverse. The external mirrors will
then return to the original position
when the lever is shifted out of the
reverse position. Each memory set of
2
25