Maserati Ghibli 2021 Owner's Manual page 131

1 st Dimmable position: allows
minimum to maximum bright-
ness tuning of the instrument
cluster dials, display, control
switches and MIA's backlight,
including all displayed mes-
sages and night lighting.
2 Stable position: allows maxi-
nd
mum brightness set.
3 Stable position: allows to
rd
switch on the main and read-
ing lights of the front dome
light.
The right regulator has 2 different
positions:
0 Stable position: night lighting
off.
(OFF)
1 Dimmable position: allows
st
minimum to maximum bright-
ness tuning of the front dome
light LED and the night light-
ing.
Multifunction Lever
The multifunction lever is fitted on the
left side of the steering column.
The multifunction lever controls
the operation of the turn signals,
headlight beam selection, overtaking
lights and windshield wiper and
washer (for this content see the
chapter "Wiper and Washer Control"
of this section).
Turn Signals
Move the multifunction lever all the
way up or down until the stop triggers.
The left or right arrow on the
speedometer and tachometer
instrument cluster respectively, flashes
to show proper operation of the front
and rear turn signal lights.
Dashboard Instruments and Controls
To activate lane change function, tap
the lever up or down once, without
moving beyond the detent. The turn
signals (right or left) will flash three
times then automatically turn off. This
function is useful when overtaking or
changing lanes.
NOTE:
• If either light remains on and does
not flash, or flashes at a fast rate,
check for a defective outside light. If
an indicator on the instrument cluster
fails while moving the lever, then the
turn indicator could be defective.
• The message that a turn signal is on
will appear in the instrument cluster
and a continuous chime will sound if
the vehicle is driven more than 1 mile
(1.6 km) with either turn signal on.
High Beams and Flashing
To switch on the high beams with
the light switch in headlamp
4
127