Maserati Ghibli 2021 Owner's Manual page 23

After these steps, the profile set will
be memorized in the selected position.
NOTE:
Memory profiles can be set without
the vehicle in P (Park), but the vehicle
must be in P (Park) to recall a memory
profile.
Pairing Remote Keyless Entry
Transmitter to Seats Memory
Your key fob can be programmed
to recall one of two programmed
memory profiles by pressing the
button on the key fob.
NOTE:
This function can be enabled or
disabled using the MIA system, refer to
"Functions of Settings Menu on MIA"
in section "Dashboard Instruments and
Controls" for further information.
To program your key fobs, perform the
following actions:
• Cycle the ignition device to the RUN
position.
• Move the seat and/or the other
adjustable devices in the position
that you wish to memorize, or recall
a previously memorized profile,
pressing the corresponding memory
button "1" or "2".
• Cycle the ignition device to the OFF
position.
• Press and release the "S" button.
• Within 5 seconds, press and release
the memory button "1" or "2".
• Press and release the button on
key fob.
• Within 3 seconds, press and release
the button on the key fob.
To check if the system has memorized
the correct profile, you can move the
seat and press the button: the seat
will move to the memorized position.
NOTE:
Your key fobs can be unlinked to your
memory settings by pressing the "S"
button followed by the
the key fob.
Memory Position Recall
NOTE:
The vehicle must be in P (Park) to
recall memory positions. If a recall is
attempted when the vehicle is not in P
(Park), a message will display in the
instrument cluster.
To recall the memory settings for
driver, press memory button number
"1" or "2" on the driver's door trim
panel or the button on the key
fob linked to memory position "1" or
"2" with ignition device in the RUN
position.
Understanding the Vehicle
A recall can be canceled by pressing
any of the buttons ("S", "1", or "2")
during a recall. When a recall is
canceled, the driver seat, external
side mirrors, adjustable pedals (
and power tilt and telescopic steering
column stop moving.
A delay of at least one second will
occur before selecting a new recall.
Easy Entry/Exit Driver Seat
This function provides automatic driver
seat positioning to enhance driver
mobility when entering and exiting
the vehicle.
button on
The distance the driver seat moves
depends on where you have the driver
seat positioned when you place the
ignition device to the OFF position.
• When you cycle the ignition to the
OFF position the driver seat:
- will move about 2.36 in (60 mm)
rearward if the driver seat position
is greater than or equal to ca. 5.51
in (140 mm) forward of the rear
stop;
- will move to a position of ca. 3.15 in
(80 mm) rearward of the rear stop if
the driver seat position is between
5.51 in (140 mm) and 3.15 in (80
mm) forward of the rear stop.
• The seat will return to its previously
set position when you place the
),
2
19