Maserati Ghibli 2021 Owner's Manual page 212

Driver Assistance Systems
horizontal bars (setting cycle
starts to 3 bars).
- CC On: pressed for 2 seconds
activates the CC system. See
chapter "Cruise Control - CC" in
this section for further details.
- Press it to switch from CC to ACC.
3. ACC ON/OFF button. If enabled,
pressing this button will disable
CC.
4. ADA ON/OFF button with ACC set
only. See "Active Driving Assist -
ADA" in this section for further
details.
NOTE:
Any change made to tire dimensions
affects performance of Adaptive Cruise
Control and Front Collision Warning, if
equipped.
6
The ACC is not activated in the
following conditions:
• When braking.
• When parking brake is activated.
• When automatic transmission is in P
(Park), R (Reverse) or N (Neutral).
• When vehicle speed is out of preset
speed range.
• When brakes are overheated.
• When driver door is open.
• When the driver's seat belt is
unbuckled.
208
• When the road is particularly steep
(both uphill and downhill) at low
speed.
• When drive mode (ESC OFF) is
selected.
• When the door is opened at low
speed.
• When there has been an ESC event in
the last 5 seconds, or is still active.
• When there is an object too close in
front of the vehicle.
It is possible that more than one
system is active at the same time such
as ACC and ABSA just to mention
some.
While activation of ACC and CC at the
same time is impossible.
Speed Range of Use
Speed MPH (km/h)
Minimum 0
Engaged/activated 20 (30)
Maximum 130 (210)
Activation/Deactivation
NOTE:
Pictures show status of ACC and LKA
systems.
Press and release ON/OFF button
to activate the ACC and enter the
"Driver Assist" page. The display will
show in the top left corner the
white symbol with below 3 dashes will
illuminate indicating that system is
ready to be set.
In the main area the symbology of
the other ADAS system set will be
displayed.
When exiting the "Drive Assist" page,
only the ADAS symbology will remain
on the top left corner.
If a vehicle is detected as being too
close, the display will show a message
for 5 seconds and trigger a buzzer to
warn the driver that current conditions
do not allow enabling of the ACC. At
any rate, system will remain in the
ready status.