Maserati Ghibli 2021 Owner's Manual page 237

• Wet roads, roads covered or partially
covered by snow.
• Construction zones.
System Operation
With ACC set (see "Adaptive Cruise
Control – ACC" in this section), ADA
system activates by simply pressing
the button on the steering wheel.
Once the conditions are met, ADA will
engage.
CAUTION!
The Active Driving Assist (ADA) system
may take up to 5 seconds to engage
once all conditions are met.
The conditions for ADA to engage are
as follows:
• ADA must be turned on or enabled.
NOTE:
In case of wet road or raining
conditions the function could be
disabled by the system in order to
minimize the risks.
• The vehicle must be on the highway
or limited access freeway, or on extra
urban roads.
• ACC must be engaged.
• Left and right visible lane lines.
• Vehicle speed must be between 0 to
90 MPH (0 and 145 km/h).
• No faults in the forward facing
camera, radar, EPS, or MIA.
• Lane width between 3 to 4.6 yd (2.8
and 4.2 m).
• Turn signal not activated.
• No faults related to this system.
Speed Range of Use
Speed MPH (km/h)
Minimum 0
Engaged/activated 0
(with ACC engaged)
Engaged/activated 20 (30)
(with ACC not en-
gaged)
Maximum 90 (145)
• If set above the maximum speed,
ADA will not function after the
vehicle speed will reach the
maximum speed.
• If set below the maximum speed and
the ACC target speed is increased,
ADA will function up to the
maximum speed and then the system
will turn off automatically.
• When the ACC target speed is
reduce and speed is lower than the
maximum speed, the system will start
automatically.
• If the ACC target speed is set under
the maximum speed, ADA is active
Driver Assistance Systems
and vehicle speed increases above the
maximum speed due to slope, ADA
will continue to function.
Monitoring on TFT Display
ADA and the other ADAS systems
conditions can be monitored on
TFT display by accessing the "Driver
Assist" page with the buttons on
the steering wheel (see "TFT Display
Setting and Menu Overview" in
section "Dashboard Instruments and
Controls").
The symbol in grey indicates that
the ADA system is active, but not
engaged and is shown at the centre
of the TFT display when the "Driver
Assist" page is displayed.
The ACC and ADA information are
shown with a telltale on the left top
corner of the TFT display when other
information (textual pop ups, NAVI
information, phone call, etc...) cover
the ADA's ones (see detail in picture).
In telltale ADA uses steering wheel
icon and corner lines to indicated its
status.
When exiting the "Driver Assist" page,
on TFT display top left corner, the
grey symbol will appear in the multiple
light of active ADAS systems.
6
233