Maserati Ghibli 2021 Owner's Manual page 213

Push the ON/OFF button a second time
and release to turn the system off.
A pop-up message is displayed for
2 seconds to indicate that ACC was
disabled.
WARNING!
Leaving the Adaptive Cruise Control
(ACC) system on when not in use is
dangerous. You could accidentally
activate the system or cause it to go
faster than you want. Always leave
the system off when you are not using
it.
Setting the Speed
When vehicle reaches required
speed, press down and release
the multifunction control (SET -).
The display will show set speed
corresponding to vehicle current one.
Speed value will be indicated below
the green symbol and above the
distance bars, in the center of the
display.
Remove foot from accelerator pedal
and vehicle will continue at set speed.
Driver Assistance Systems
Driver Override
If the driver accelerates beyond the
set speed or faster than the car would
do with ACC engaged, the set speed
below the green light will blink
and the time gap bars will vanish
to indicate that in this condition
the system cannot control the
distance between vehicle and sensed
vehicle ahead. Vehicle speed will be
determined only by the accelerator
pedal position.
Changing Speed Setting
Once speed is set, driver can increase
or decrease it by respectively pressing
multifunction control up (RES +) or
down (SET -). Speed can be increased
or decreased in two ways:
• Pressing control once, set speed will
increase or decrease by one unit
corresponding to 1 MPH (1 km/h).
• Hold the control to increase or
decrease set speed by 5 MPH (10
km/h) at a time.
NOTE:
• When pressing the multifunction
control up (RES +) or down (SET -),
the new set speed will be the current
speed of the vehicle.
• When using (SET -) control to
decelerate, if the engine braking
6
(Continued)
209