Changing The Pads; Filling The Water Tank During Operation; Using Accessories For Carpet Cleaning; Ending Operation - Silvercrest SDB 1500 A1 Operation And Safety Notes

Start-up
with a standard commercially available descal-
ing agent or with a little vinegar.
Insert the plug into an earthed socket. When
the function display
switched on and the boiler has begun to heat up.
Hoover the floor to be cleaned before you start
to generate steam.
Start to generate steam by pressing the steam
button (Fig. L).
16
ATTENTION! Never use the device without a
pad ! Risk of damage and scratching to the
8
floor. The pad
8
service centres.
Press the steam button
steam function.
ATTENTION! RISK OF BURNS! Take care
when removing the pad
base does not tip over.
9
Remove the plug from the socket. Wait for at
least 5 minutes until the steam base
pad have been allowed to cool.
8

Changing the pads

If you change from a hard floor to a soft floor
when cleaning, you should also change the
pad .
8
Remove the plug from the socket. Wait for at
least 5 minutes until the steam base
pad have been allowed to cool.
8
ATTENTION! RISK OF BURNS! Take care
when removing the pad
steam base is not knocked over.
9
Remove the pad
Place the new pad
base onto the relevant felt attachment
9
(Fig. J).
Insert the mains plug into the mains socket.
When the function display
vice is switched on and the boiler has begun to
heat up. You can now start steam operation.
42 GB
114903_silv_Dampfbesen SDB 1500 A1_content_DE_AT_CH.indd 42
lights up, the device is
13
is available at authorised
again to stop the
16
that the steam
8
and the
9
and the
9
and that the
8a 8b
or .
8a 8b
or under the steam
8a 8b
19
lights up, the de-
13
Filling the water tank
during operation
If the water in the water tank
the steam button to discontinue steam pro-
16
duction.
Remove the plug from the socket and remove -
as previously described - the water tank
Fill the water tank with cold, still water.
11
In cases of particularly hard water (with a
water hardness of more than 2 mmol / l), use a
mixture of 50% tap water and 50% distilled
water.
Re-insert the water tanks - as previously
described - and continue steam operation.
Using accessories for
carpet cleaning
ATTENTION! This attachment is only suitable
for cleaning carpets and soft surfaces. Do not
use the attachment on hard surfaces.
Ensure that the pad under the steam
8
base is attached to the appropriate felt
9
attachments .
19
Place the attachment with the flat side on
17
the floor. Attach the device to the attachment
(fig. K).
The device is now ready for carpet cleaning.

Ending operation

Press the steam button to cease steam
16
production.
Remove the mains cable
4
Empty the water tank completely
build-up of limescale caused by standing water.
ATTENTION! Wait for at least 5 minutes until
the steam base and the pad
9
allowed to cool! Risk of burns!
Remove the pad .
8
Wrap the mains cable around the cable
4
winder and .
3 14
Press the handle release button
runs out, press
11
.
11
17
from the socket.
to avoid a
11
have been
8
.
1
09.06.15 08:55