Page 1
Operating Instructions Control Units for Belt Drives EBC 3000 Rhein-Nadel Automation GmbH Rhein - Nadel Automation GmbH 14.04.14 VT-BA EBC 3000GB...
Page 2
Table of Contents Chapter .......................... Page Technical Data Safety Instructions ..................Starting Instructions ..................Dimensioned Drawing ..................Connection Diagram ..................Declaration of Conformity in terms of the Low Voltage Directive 2014/35/EU and the EMC Directive 2014/30/EU We herewith declare that the product is in conformity with the following provisions: Low Voltage Guideline 2014/35/EU EMC Directive 2014/30/EU Applied harmonised standards:...
Page 3
One must make sure that every person working with this control unit is acquainted with the safety instructions and also follows them. The unit described here is a controller for the operation of RNA belt drives. The limiting values in Technical Data are to be observed.
Page 4
Note! This hand indicates that there are tips on how to use the control unit. Attention! This warning triangle indicates safety instructions. Non-observance of this warning can result in serious injuries or death! Work on electrical equipment of the machine/installation may only be carried out by a qualified electrician or by an instructed person under the directions and supervision of a qualified electrician according to the electrotechnical regulations! Please observe all notes on safety and danger on the machine/installation!
Page 5
Before opening the control unit pull the mains plug! Then wait 10 min. until the power pack is discharged. Connection is done on the XK1 terminal strip. In control mode with 0-10 volts onto terminal XK1.3 +10 volts Terminal XK1.5 GND In control mode with 0-20mA onto terminal XK1.4 +20mA Terminal XK1.5 GND...
Need help?
Do you have a question about the EBC 3000 and is the answer not in the manual?
Questions and answers