Advertisement

MRS Quattro
EN - Installation manual
BM22001 Rev. B 2021-06-03

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Molift MRS Quattro and is the answer not in the manual?

Questions and answers

Summary of Contents for Etac Molift MRS Quattro

  • Page 1 MRS Quattro EN - Installation manual BM22001 Rev. B 2021-06-03...
  • Page 2: Table Of Contents

    Molift MRS Quattro / www.etac.com English Manual Content Important MRS Quattro ..........2 This User Manual contains important safety MRS components ........2 instructions and information regarding the use of About MRS Quattro ........2 the Quattro and accessories. General .............3 Declaration of conformity ......3 In this manual, the user is the person being lifted.
  • Page 3: Mrs Quattro

    Molift MRS Quattro / www.etac.com MRS Quattro MRS Quattro components: Traverse Boom boom Quattro corner Traverse trolley Product label Control label Foot About MRS Quattro MRS Quattro is a gantry intended for Molift Air not possible or desirable, but can also be used in and Molift Nomad hoists.
  • Page 4: General

    We recommend only using Molift components and spare parts. Declaration of conformity is not valid and Etac is not responsible for warranty if any modifications are made to the product. Etac shall not be liable for faults or accidents that can occur when using components made by other manufacturers.
  • Page 5: Technical Data

    Molift MRS Quattro / www.etac.com Technical Data Safe Working Load (SWL) 300 kg (661 lbs) Weight of unit Boom Kg/m: 4,2 kg/m/8,8 lbs/m Leg with adjustable foot: 8,5 kg/18,7 lbs Corner: 2,7kg/6,0 lbs Total weight (Complete unit): 110,95kg ( 3x3m )
  • Page 6: Assembly

    Molift MRS Quattro / www.etac.com Assembly Supplied parts Make sure the following parts are included in the package. Mounting Quattro Frame Tip: To facilitate the installation, make 4 support blocks, approximately 150 mm high. 1. Make sure you have free space of aprox.. 3x4 meters in the room where the MRS Quattro will be mounted.
  • Page 7: Tip: Perpendicular Frame

    Molift MRS Quattro / www.etac.com Assembly Tip: Perpendicular frame. If possible, use a tape measure to check that the Quattro Frame is perpendicular. 1. Measure the diagonal length corner-to-corner. The length shall be the same both ways. 2. If not; loosen the bolts and adjust.
  • Page 8: Mounting Of Legs, Ceiling Height >2,4 M

    Molift MRS Quattro / www.etac.com Assembly Mounting of legs, Ceiling height = 2,4 m Start from step: Perpendicular frame. 1. Detach one boom and keep the corners on. 2. Move the traverse boom to a position close the open ends.
  • Page 9: Check List Before Use

    Molift MRS Quattro / www.etac.com Assembly Check list before use Don’t start using MRS Quattro before completing control accord- ing to checklist after assembly. Use this checklist to verify that the MRS Quattro is properly installed and can operate correctly and safely before use.
  • Page 10 Molift MRS Quattro / www.etac.com Assembly 1. Attach the adjustable feet. 2. Adjust the levelling feet for horizontal position of MRS Quattro. Unscrewing the foot too much can cause the foot to come loose.
  • Page 11: How To Use Mrs Quattro

    Molift MRS Quattro / www.etac.com How to use MRS Quattro Lifting user Read the user manual for Molfit Air or Nomad before lifting patient. Never lift the user higher than necessary to carry out a lift. Never leave a user unattended in a lifting situation.
  • Page 12: Accessories

    Molift MRS Quattro / www.etac.com Accessories Battery charger Molift Nomad Molift Air or Molift Nomad ceiling hoist is charged Molift Nomad portable hoist is suitable for use through the hand control. The hand control with MRS Quattro. charger can be mounted on the MRS Quattro.
  • Page 13: Adjustable Foot

    Molift MRS Quattro / www.etac.com Accessories Adjustable foot Adjustable feet are available for MRS Quattro. Adjustable foot for MRS Quattro Art. no.: 1610200 In Rail Charging System Possible to use the in rail charging system with the MRS Quattro. Contact supplier or molift.com for...
  • Page 14: Maintenance

    (particularly of the MRS Quattro structure, bolts inspection is performed and a label (with 6-digit and person-support devices according to Periodic ID from Etac or distributor) showing who has per- Inspection Report for MRS Quattro. This can be formed the periodic control. The control label can found on www.etac.com.
  • Page 15: Troubleshooting

    Molift MRS Quattro / www.etac.com Troubleshooting Symptom Possible Cause/Action Wobbly between leg and frame. Check bolts in corner. Make sure bolts is properly thightened. Adjustable foot adjusted up too much Wobbly between Traverse boom and frame. Check bolts between bracket and boom. Make sure bolts are properly thightened.
  • Page 16 Etac A/S Parallelvej 3 DK-8751 Gedved www.etac.com...

Table of Contents