Table of Contents
Advertisement
7–iSCSI Extensions for RDMA
Configuring iSER for RHEL
8.
You can use a Linux TCM-LIO target with which to test iSER. The setup is
the same for any iSCSI target, except you type command
enable_iser Boolean=true on the applicable portals. The portal
instances are identified as "iser" as shown in the following figure:
9.
Install Linux iSCSI Initiator Utilities using the
yum install iscsi-initiator-utils commands.
a.
b.
c.
Discover the iSER target by typing command such as the following:
iscsiadm -m discovery -t st -p 192.168.100.99:3260
Change the transport mode to iSER by typing command such as the
following:
iscsiadm -m node -T iqn.2015-06.test.target1 -o update -n
iface.transport_name -v iser
Connect to or login to the iSER target by typing a command such as
the following:
iscsiadm -m node -l -p 192.168.100.99:3260 -T
iqn.2015-06.test.target1
64
BC0154503-00 B
Advertisement
Table of Contents
