Table of Contents
Advertisement
7–iSCSI Extensions for RDMA
Configuring iSER for RHEL
4.
Load the RDMA services.
systemctl start rdma
modprobe qed
modprobe qede
modprobe qedr
modprobe ib_iser
modprobe ib_isert
5.
Verify all RDMA and iSER modules loaded on the initiator and target devices
using the lsmod | grep qed and lsmod | grep iser commands.
6.
Verify that there are separate hca_id instances by typing the ibv_devinfo
command, as described in
7.
Check the RDMA connection on the initiator device and the target device.
Initiator device:
rping -s -C 10 -v
Target device:
rping -c -a 192.168.100.99 -C 10 -v
The following figure shows an example of a successful RDMA ping.
Step 6
on
page
59.
63
BC0154503-00 B
Advertisement
Table of Contents
