See also
Terminal assignment (Page 5-3)
Cable gland (Page 5-3)
Connect the ground (Page 5-10)
5.8
Connecting the power supply
Procedure
The procedure for connecting the power supply is as follows:
1. Pass the connecting cable through the cable joint (7).
2. Connect L+ and L- to clamps 11 and 12. A particular polarity is not necessary.
See also
Terminal assignment (Page 5-3)
Cable gland (Page 5-3)
Connect the ground (Page 5-10)
Technical data for the device (Page 9-1)
SITRANS DA400 with protection against explosion
Operating Instructions, 02/2006, A5E00684661-01
Note
Electromagnetic compatibility
To guarantee high EMC resistance, the ground cable should be kept as short as possible.
Notice
Explosion protection
Use only approved safe feed sources, as described in the chapter "Technical Data."
Connecting
5.8 Connecting the power supply
5-9