Advertisement
GEAX
s.r.l.
• Release the cable gland springs
•
prepare the new rope according to
• Secure the end of the new rope to the winding drum by wrapping it around
the "A" thimble
rubber hammer as shown in
• control the rewinding by accompanying the rope so that it lays in adjacent
turns that are neatly side by side; do not put your hands near the winch
drum while it is rewinding (stay at least 1 metre away); to juxtapose the
turns use a copper hammer;
• When rewinding is almost completed, position the cable gland by hanging
the spring
fig.3.2.3.5
• Check the thrust bearing condition by opening the swivel, not only when it
is considered to be the cause of rope damage;
MAINTENANCE ACCORDING TO THE CONDITIONS OF THE DRILLING M.
Chapter 3
fig.3.2.3.5
fig.3.2.3.6
, clamping it inside the pocket using a copper or
fig.3.2.3.2
fig.3.2.3.4
;
fig. 3.2.3.5;
fig.3.2.3.6
;
3-8
Advertisement
