Fujitsu ARYG72LHTA Service Instruction page 52

Trouble shooting 14 rouble shooting 14
INDOOR UNIT Error Method: INDOOR UNIT Error Method:
Indoor Heat Ex. Thermistor Error
Detective Actuators:
Indoor Unit Controller PCB
Heat Exchanger (MID) Thermistor
Forecast of Cause : 1. Connector failure connection
Check Point 1 : Check connection of Connector
Check if connector is loose or removed
Check erroneous connection
Check if thermistor cable is open
>>Reset Power when reinstalling due to removed connector or incorrect wiring.
OK
Check Point 2 : Remove connector and check Thermistor resistance value
Thermistor Characteristics(Rough value)
Temperature (°C )
Resistance value (k )
Temperature (°C )
Resistance value (k )
If Thermistor is either open or shorted, replace it and reset the power.
OK
Check Point 3 : Check voltage of Controller PCB (DC5.0V)
Make sure circuit diagram of each indoor unit and check terminal voltage at Thermistor (DC5.0V)
BLACK
1 1
CN8
BLACK
2 2
BLACK
1 1
CN6
2 2
BLACK
3 3
If the voltage does not appear, replace Controller PCB and execute the check operation again.
Indicate or Display:
Error code : 42
Detective details:
Indoor unit thermistor is open or short is detected always.
0 5 10
176 134 103
40 45 50
25.6 20.8 17.1
Room Temp. Thermistor
H/E Thermistor
Outdoor unit :
POWER
ERROR
MODE
2
2. Thermistor failure 3. Controller PCB failure
15 20 25
80.3 62.9 49.7
02-16
PUMP LOW PEAK
DOWN NOISE CUT
(L1) (L2) (L3) (L4) (L5) (L6)
5 15
30 35
39.6 31.7
DC