Related Manuals for TCL TRF-275W
Summary of Contents for TCL TRF-275W
- Page 1 TCL Home Appliances (HeFei) Co., Ltd. Refrigerator Disassembly Manual Product model: TRF-275W/305W/315W...
- Page 2 Disassembly Guide Guidelines Required tools: 1. A pair of white gloves 2. A Phillips screwdriver 3. A sleeve (size: 8mm) 4. Pincer pliers A pair of white gloves A Phillips A sleeve (size: 8mm) Pincer pliers screwdriver (electric)
- Page 3 Disassembly Guide Disassembly guidelines for refrigerator chamber door 3. Loosen the communication 1. Use a Phillips screwdriver 2. Use an 8mm sleeve to wiring harness terminal and to first remove two screws loosen three screws of remove the upper hinge from the upper hinge cover, the upper hinge, and and then remove the hinge...
- Page 4 Disassembly Guide Disassembly guidelines for freezer door 1. Use an 8mm sleeve to 2. After removing the middle loosen two screws of the hinge, lift the freezer door middle hinge, and then upwards slightly and remove it; unscrew them with a Phillips screwdriver;...
- Page 5 Disassembly Guide Step I: Remove the 2 screws at the rear of the assembly Step II: Pull down the top light from the rear State after the disassembly as shown in the figure, and unplug the 4 connecting terminals...
- Page 6 Disassembly Guide Step I: Disassemble the refrigerating air duct assembly from the top down Step II: Disassemble the refrigerating air duct assembly from the refrigerator, as shown in the diagram, and unplug the connecting terminals...
- Page 7 Disassembly Guide Step I: Use a screwdriver to remove the fixing screws of freezing air duct; Step II: Pull out the air duct from below; Step III: Unplug the freezing air duct terminal and take out the freezing air duct;...
- Page 8 Disassembly Guide Step I: Use a screwdriver to remove the fixing screws of evaporator; Step II: Use pincer pliers to cut off the evaporator tube and remove the evaporator;...
- Page 9 Disassembly Guide Step I: Use pincer pliers to cut off all the high and low pressure pipelines of the compressor chamber; Step II: Use an 8mm sleeve and a Phillips Step III: Use an 8mm sleeve and a Phillips screwdriver to loosen four fixing screws on the screwdriver to remove fixing screws on the bottom of the compressor, and then remove the bottom of the compressor, and finally...