Advertisement
PA-2013 Motherboard Manual
Clear Password: CPS
This jumper allows you to enable or to disable the password configuration. You
may need to enable this jumper by shorting it with a jumper cap if you forget
your password. To clear the password setting: 1. Turn off your computer, (2).
Short this jumper by placing a jumper cap on it, (3) Turn on your computer,
(4), Hold down the Delete key during boot and enter BIOS Setup to re-enter
user preferences, (5) Turn off your computer, (6) Remove the jumper cap, (7)
Turn on your computer for the new settings to take effect.
Flash ROM Type Selection: EP1, EP2
These two jumpers allow you to configure the type of flash ROM chip. This
jumper setting is correct by manufactory default. If you want to know the flash
ROM type installed on this motherboard, remove the sticker from the chip to
see its type.
2
Advertisement
