Configuring Abb I/O Device Using The Flexpendant - ABB Discrete I/O Applications Manual

3.2.2 Configuring ABB I/O device using the FlexPendant

General
This section describes the recommended working procedure when installing and
configuring the ABB I/O devices in FlexPendant. For information on configuring
I/O devices using RobotStudio, see
on page
Configuring a Discrete I/O device
Use this procedure to configure a new Discrete I/O device on the FlexPendant.
Application manual - Discrete I/O
3HAC070208-001 Revision: C
42.
Note
The system should be in manual mode, while configuring or updating the I/O
device using the FlexPendant.
1 Start the FlexPendant and connect to the OmniCore controller.
2 On the start screen, tap I/O, and then select I/O Devices from the menu.
3 Select the I/O device and and tap Configure.
xx1900000918
© Copyright 20192020 ABB. All rights reserved.
3.2.2 Configuring ABB I/O device using the FlexPendant
Configuring ABB I/O device using RobotStudio
3 Software overview
Continues on next page
49