Table of Contents
Advertisement
Available languages
Available languages
ENGLISH
Maintenance
9.
MAINTENANcE
DANGER!
TIME
Before starting work
Weekly/daily
10. WHAT TO DO IF?
10.1
Fault elimination
FAULT
Motor of the ESG Plus does not
run.
The ESG Plus head does not stick.
The diamond wheel does not
rotate.
Unbalance of the grinding wheel
when started up.
10.2
Servicing/customer service
The following data are required to order spare parts:
• Machine model: (example: ESG Plus)
• Machine No.: see rating plate
X For ordering spare parts, see the separate spare part list.
X Contact your local branch directly in order to eliminate problematic situations.
34
ORBITALUM TOOLS GmbH D-78224 Singen www.orbitalum.com
Danger of death by electric shock!
Non-observance could result in death or critical injury.
X Before maintenance work remove the mains plug.
AcTIVITY
X The connection of the ESG Plus head to the motor has to be firm.
X The device may not be moist and may not be used in a humid environment.
X No unbalance in the grinding wheel may occur when the machine is switched on.
X Check whether ESG Plus head and/or the Torx screw sit firm, if necessary tighten.
X Check the power supply cable for damage.
X The tapped hole at the ESG Plus must always be free of dust, clean if necessary.
X Remove dust from the inside of the housing, clean.
X When using the protective cover:
To avoid bearing damage caused by fine dust particles, the inside of the housing of the
ESG Plus should be thoroughly cleaned after each use.
POSSIBLE cAUSE
X Power cable defective.
X Motor defective.
X ESG Plus head is not correctly fastened
to the motor flange.
X No mains voltage.
X Motor defective.
X Grinding wheel mounted incorrectly.
ESG PLUS, ESG PLUS²
REMEDY
X Replace the power cable.
X Replace the motor.
X Tighten the Torx screw.
X Check mains voltage.
X Replace the motor.
X Tighten or replace the grinding wheel
immediately.
[REV. 20200417] OW_ESG_BA_790052773_00__INH-02_EN
Advertisement
Chapters
Table of Contents
