Surface-Grinding The Electrode Tip; Cutting The Electrodes To Length; Switching Off The Esg Plus - Orbitalum ESG Plus Translation Of Original Operating Instructions

ENGLISH
Operation
7.2.2 Surface-grinding the electrode
tip
The electrode ist sharpened with the ESG Plus. The tip can be
squared to influence the arc during welding positively.
X Insert the electrode (1.0/1.6/2.0/2.4/3.2 or 4.0 mm)
through the openings at the front end onto the grinding
wheel and square the electrode tip.
7.2.3

cutting the electrodes to length

In order for the electrode rods to be used for e.g. orbital
welding, or for manual welding, they have to be cut to length.
1. Insert the electrode into the lateral slot.
2. The electrode is cut evenly by turning the electrode
slowly (optional cutting device for 12, 13, 15 and 17 mm,
see chap. 3.1.2, p. 25).
7.3

Switching off the ESG Plus

X Press the ON/OFF switch (1).
The ESG Plus stops.
30
ORBITALUM TOOLS GmbH D-78224 Singen www.orbitalum.com
ESG PLUS, ESG PLUS²
[REV. 20200417] OW_ESG_BA_790052773_00__INH-02_EN