Table of Contents
Advertisement
7 . 1 K n i f e c h a n g i n g
Socket cap screws to fixed knife no. 1
The socket cap screws which fasten the support rules and the fixed knife pair, are
undone from rear side of the cutter housing.
3
Mark and lift out the support rules to the fixed knife pair.
4
Mark and lift out the fixed knife pair.
5
Clean the knife positions where the knives were located.
Fixed knife no. 2 (front)
1
Undo and remove the socket cap screws which fasten the support rules and the
fixed knife pair (hex 17 mm).
Support rule
Fixed knife pair no. 2 (front)
The socket cap screws which fasten the support rules and the fixed knife pair, are
undone from inside of the cutter house door.
NOTE: Hold both the support rule and the fixed knife, when undone and removing the
last screw to the support rule.
( c o n t i n u e d )
Support rule
NOTE: The fixed knife
and the support rules
are heavy, be careful!
S e r v i c e l
7 - 7
Advertisement
Table of Contents
