Table of Contents
Advertisement
1 1 . 4 B l o w e r F 2 5 a n d F 4 0
Conair's blowers F25 and F40 are intended for dust and
material conveying.
NOTE: The temperature of the conveyed material must never exceed 80°C.
It is not permitted to use the blowers in surroundings where the
temperature exceeds 40°C or goes below -20°C.
It is not permitted to rebuilt, modify or use the blowers in
explosive atmospheres. F25 and F40 are available with or
without soundproofing.
Safety
The following safety advice must be observed, to avoid personal
injury, damage to peripheral equipment and to the fan itself.
It is not permitted to use the blowers in humid environments or
unprotected outdoors.
WARNING! F25 and F40 have very high suction power.
Ensure that no large pieces of plastic are drawn into the blower. If large
pieces of plastic are drawn into the blower they could seriously damage the
impeller and blower housing.
Objects and clothing can easily be sucked into the blower inlet and cause personal
injury. Blowers F25 and F40 must therefore never be used with an unprotected
inlet opening.
WARNING! F25 and F40 produce a very powerful stream of air at the dis-
charge opening.
NOTE: The stream of air from the discharge opening is very powerful. Granulate and objects
which have been sucked in to the blower, will be thrown out at very high speed and can cause
personal injury. Never put the hand directly in front of the blower discharge opening.
Electrical connection
Electrical connection must only be done by a competent electrician.
Sound level
The sound pressure level is not the same at different blower speeds. If a fan
is used without a sound-damping housing, ear protection should be used to
prevent hearing damage.
(continued)
O p t i o n s l
1 1 - 7
Advertisement
Table of Contents
