Conair 18 Series User Manual page 67

NOTE: The hopper must be
closed,before closing the cut-
ter house door.
NOTE: Never use help when
closing the cutter house
door. Close the cutter house
door alone!
6 - 1 4 l O p e r a t i o n a n d D a i l y M a i n t e n a n c e
10
Close the cutter house door.
The cutter house door is
heavy. The risk of injuring
fingers or hands increases
when two or more
persons works, to
close the cutter house
door.
Be careful!
11
Install and fasten the
short pipe stub with
the coupling rings.
12
Clean and make sure that there are no granulate left in the space outside the
cutter housing and inside the granulator encapsulating before closing the doors.
13
Close the doors.
14
Install the flaps in hopper.
– Unit with extraction fan and sound proofing: Fold the forward flap 90º
upwards, lift and slide the flap package straight in.
– Unit with extraction fan, sound proofing, and conveyor: Install the inner
flap and the outer flaps.
NOTE: Check and make sure that there are no granulate and plastic residue left on
the floor after cleaning.
Warning! Granulate and plastic rests cause
slipping risk!
15
Check that the hopper is empty.
16
Turn the main switch to position "1" On.
17
Check that the emergency stop not is activated.
18
Reset the safety relay, press the "Reset safety
relay" button.
19
Start the granulator, press the "Start" button.
Start
Reset safety
relay
Emergency
stop