Table of Contents
Advertisement
1 1 . 7 B a n d c o n v e y o r
The band conveyor is designed for transporting plastic waste. The conveyor is con-
structed from steel beam. The frame pieces are assembled with cross sections and screw.
The conveyor can be fitted with a metal detector.
Instructions for the metal detector, see separate instruction manual.
Safety
When performing any work with the band conveyor, both the circuit-breaker and
the main switch must be "Off". Alternatively, the connector must be pulled out of
the power point on the granulator's electrical cabinet!
The conveyor is designed for plastic waste. Do not use the conveyor for tasks other
than it is intended for.
Nobody should be on the conveyor or step on it during operation.
If the conveyor has stopped due to an error, or if the emergency stop has been
pressed, it must not be re-started until the cause has been established and the
appropriate action has been taken.
Mobile conveyors must always be transported in a lowered position.
Warning! When using the conveyor belt with carriers: Be careful not to let
the carriers catch your foot, arm, or article of clothing.
Band conveyor with sound trap
The sound trap makes that the center of gravity for the conveyor
come high up. The conveyor can easily fall or tip over
when being moved or lifted.
Installation
When installing, adjust so that the band
conveyor is balanced diagonally.
If the floor of the installation site
is very uneven, it should be
made even before installation.
NOTE: Be careful when moving
or transporting the conveyor.
(continued)
O p t i o n s l
1 1 - 1 1
Advertisement
Table of Contents
