Table of Contents
Advertisement
1 1 . 7 B a n d c o n v e y o r
( c o n t i n u e d )
Electrical connection
The band conveyor should be connected up by an authorized electrician.
Connect the band conveyor to the electrical cabinet with a connector.
Alternatively, connect the cable to electrical cabinet according to the markings and
the granulator's wiring diagram.
Switch on the main switch on the electrical cabinet. Press the start button and
check that the belt moves in the right direction.
If the belt moves in the wrong direction.
Shift the two phases in connection to the contactor for the band conveyor in the
electrical cabinet. Alternatively, shift the two phases in the connection to the
connector.
Starting
When the band conveyor is started for the first time, the belt's position on the
rollers should be checked. The belt must not move obliquely.
If the belt moves obliquely.
To gain access to the adjusting screws, remove the hoods by the turning roller.
When the belt moves obliquely. Screw only one adjusting screw at a time.
Only screw a 1/4 turn.
Wait and let the belt move for a few minutes.
Check, adjust, wait, and check again
until the belt moves straight.
Belt tension.
The conveyor belt's length
has 1% tolerance. Never
tension the belt's adjusting
screws with a greater tightening torque than 5 Nm.
When the belt has been adjusted. Stop the band conveyor and fit the hoods.
Maintenance
During all maintenance work on the band conveyor, both the circuit-breaker and
the main switch must be "Off". Alternatively, the connector must be pulled out of
the power point!
(continued)
1 1 - 1 2
l O p t i o n s
Advertisement
Table of Contents
