Table of Contents
Advertisement
P/N 0425683_M
ADJUSTING DOOR SAG
To adjust door sag (saw-tooth effect from door to
door), loosen the two hinge plate mounting screws
using a Torx Plus no. 27 bit. Adjust hinge plate as
needed, then tighten the screws. See Figure 2.
Figure 2. Adjusting Door Sag
CONDITIONING GASKETS
The manufacturer cannot control the environment
surrounding cases during shipment. Temperature and
humidity fluctuations during shipment, as well as
excessive vibration, may promote gaps between gasket
and frame. These gaps prevent gaskets from sealing
even when correctly fitted at the factory. This is not a
warranty issue or defect.
Gap
Before and After Gasket Conditioning
2
Follow this procedure to ensure gaps close and gaskets
seal properly:
1. Remove all shipping retainers and all packing
material.
2. Close each door. Use a flashlight to identify any
gaps between frame and gasket.
3. Energize all anti-sweat, fan and light circuits for at
least two hours, but not more than four hours, prior to
Loosen both
initiating the refrigeration cycle.
hinge plate
mounting
screws.
4. Monitor all gaps. If gaps remain at the end of four
hours, follow the procedure for Restoring Gasket Seal,
beginning on page 6 of this manual.
5. Initiate cooling sequence once gaps disappear.
Do not exceed 8 hours of energized circuits without
refrigeration. Doing so may cause damage to the case
Gap Closed
and will void the warranty.
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • WWW.HUSSMANN.COM
ATTENTION
TO ENSURE PROPER DOOR GASKET SEAL - REMOVE ALL SHIPPING
RETAINERS AND ENERGIZE ALL ANTI-SWEAT, FAN & LIGHT CIRCUITS
2 TO 4 HOURS PRIOR TO INITITAING REFRIGERATION CYCLE.
DO NOT EXCEED 8 HOURS OF ENERGIZED CIRCUITS
WITHOUT REFRIGERATION. DAMAGE OR PRODUCT FAILURE MAY
OCCUR AND VOID THE WARRANTY.
DO NOT REMOVE THIS LABEL UNTIL REFRIGERATION IS INITIATED.
Advertisement
Table of Contents
