Led Power Supply Replacement - Hussmann Innovator Installation & Operation Manual

P/N 0425683_M
6. Remove fixture:
Center LED light fixtures are installed in pairs.
(A) The fixtures are held in the mullions with
plastic clips. Gently twist the light fixture in the oppo-
site direction until it pops off the mounting clip.
(B) Continue to support the fixture while repeating
the process for all remaining clips.
(C) Each EcoShine LED fixture is shipped with
a protective film over the lens. Be sure to remove this
film.
7. Install replacement LED fixture.

LED POWER SUPPLY REPLACEMENT

Power supplies are located in the wireway below the
door frame as shown in Figure 22.
To access the wireway, remove the bumper, then
remove the #8 hex head screws that hold on the front
painted panel.
Figure 22. Power Supply Location
Part Number: 0499399 OEM
18
Power Supply
4481668 Aftermarket
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • WWW.HUSSMANN.COM
Mullion Wiring
Fixture Wiring Splice
with Shrink Tube
Clear Lens
LED Fixture 1
Figure 21. Replace with new Fixture
(Center Mullion Shown)
Mullion
LED Fixture 2
Mounting Clip