Advertisement
AMTI Force Plate System Setup Guide
Step 2
Insert the devices to be used for the measurement into
the configuration by dragging a device in the list of
Available Devices to the Devices in your
configuration window.
Select the desired signals to include in the
measurement configuration. 3D force and moment
signals are available.
Note: If you are using 2 force plates for force analysis,
designate each force plate as RT or LT under the Side
option.
Step 2 (Versions 3.16 and later)
Follow Step 2 like above. Instead of seeing channels to
select, you will see the radio buttons to designate the
side of the plate and other options to configure COP
tracing relative to body position.
Measure the gap between your two force plates with a
ruler to estimate the most accurate "Gap between
plates."
Note: For more information on how to configure these
settings, please view our video tutorials on our website:
https://www.noraxon.com/video-tutorials/
Step 3
Continue to the next step by selecting Measure.
Step 4
If you are using MR 3.14 or earlier, calibrate the force
plate baseline values by choosing 'Calibrate baselines.
If you are using MR 3.16 or newer, the force plates are
calibrated automatically upon activation. They do not
need to be calibrated before measuring.
Select Record.
Record your signal based on predetermined protocols.
After performing desired movements in the record, click
Stop and Save.
Chose Discard & measure again or Save after typing
your chosen record name.
(Rev B)
9
Advertisement
