Advertisement
AMTI Force Plate System Setup Guide
2.2 Analog Integration
Step 1-
Connect the Accupower Force Plate to the PJB-101 Junction box using the RJ11 cables. Connect the power supply.
Step 2-
Connect the 222K cable to each force plate (if applicable) and connect the single end to the Noraxon AIS.
Step 3-
Connect the AIS to the PC using the USB A to B cable (CBL02).
Step 4 (optional) –
Connect the AIS to the Noraxon MyoSync using 3.5 mm stereo cable. Connect the MyoSync to the PC using the USB A
to B cable.
3 Installing the Companion Software - myoResearch™ 3
To utilize the full functionality of the AMTI force plate system, ensure the system has updated drivers. Noraxon's
myoResearch 3 needs to be installed on the computer.
If integrating digitally with an Optima or Gen5 amplifier, Gen5/Optima drivers are required, which are pre-installed by the
MR3 software installation.
Software Installation
Within the package the myoMOTION System was shipped in, there is a
USB flash drive containing the latest myoResearch 3 software.
1. Insert the MR3 USB flash drive into the PC
2. A menu will automatically pop up
3. Click on the Noraxon installation file and follow the Wizard's
instructions
Activating the Software
The installed companion software must be activated before unrestricted use is possible.
(Rev B)
5
Advertisement
