Hilti SD 2500 Operating Instructions Manual page 9

5 Operation
5.1 Preparations at the workplace
CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Unplug the supply cord before making adjustments to the power tool or before changing
accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1.1 Repositioning the universal hook
1. Press both battery release buttons simultaneously and pull the battery out of the screwdriver.
2. Release the two screws securing the universal hook.
3. Reposition the universal hook and threaded block on the opposite side of the tool.
4. Reinsert and tighten the two retaining screws.
5.1.2 Working safely with the universal hook
▶ Before beginning the work, make sure that the universal hook is securely attached to the screwdriver.
▶ Use the universal hook only when necessary. Lay the screwdriver down in a safe place when it is not in
use for a long period.
5.1.3 Forward / reverse
Note
The control switch is locked when the forward / reverse switch is in the middle position (safety lock).
▶ Set the forward / reverse selector switch to forward or reverse rotation.
5.2 Changing the accessory tool.
1. Pull the depth gauge away from the power tool, releasing the snap-on connection.
2. Push the chuck towards the screwdriver, turning the chuck slightly at the same time, and then hold it in
this position.
3. Remove the accessory tool with your other hand.
4. Insert the desired accessory tool in the chuck, pushing it into the screwdriver as far as it will go.
5.3 Types of work
Observe the safety instructions and warnings in this documentation and on the product.
5.3.1 Driving screws
WARNING
Electrical hazards There is a risk of electric shock if a screw is driven into a concealed electric cable
and, at the same time, the bit holder or depth gauge is touched.
▶ Hold the screwdriver only by the grip when driving or removing screws.
1. Set the screwdriver to forward rotation.
2. Check that the battery is in the working position.
3. Position the screw on the bit and bring the tip of the screw into contact with the working surface.
4. Use the control switch to regulate the speed of the screwdriver.
5.3.2 Removing screws
1. Pull the depth gauge off.
2. Set the screwdriver to reverse rotation.
3. Insert the bit in the head of the screw and use the control switch to regulate the speed of the screwdriver.
4. Refit the depth gauge after removing the screws.
Printed: 20.04.2017 | Doc-Nr: PUB / 5135889 / 000 / 01 Printed: 20.04.2017 | Doc-Nr: PUB / 5135889 / 000 / 02
2
3
English 5