As-I Module; Pc Set-Up Software - Toshiba TMC7 Series Product Manual

2 0 to 7
3 0
1
2 to 7
4 0 to 7
5 0 to 7
6 1 0 to 7
7 1 0 to 7
8 0 to 7
9 to 13 0 to 7
1 Only available from TMC7 units with serial number format xxxxx-4 or more.
5.6

AS-i Module

The AS-i Module can be used with the TMC7 to enable control and monitoring via an AS-i network.
(Under development).
5.7

PC Set-up Software

The PC Set-up Software can be used with both the TMC7 and TMS7 soft starters to provide the following functionality for networks of up
to 99 soft starters.
Operational Control
(start, stop, reset, quick stop)
Status monitoring
(ready, starting, running, stopping, tripped)
Performance monitoring
(motor current, motor temperature)
Upload parameter settings
Download parameter settings
System Requirements
• Pentium II 266 Mhz processor
• 64 MB RAM.
•
12 MB free space on hard disk.
• Microsoft Mouse or other compatible pointing device.
• EGA, VGA, or compatible display (VGA or higher is recommended).
•
An RS485 communication port or RS232 to RS485 converter
• Microsoft Windows 95, 98, 2000, NT or XP.
Additionally, each TMC7 soft starter connected to the network must be fitted with a MODBUS Module (TMC7-MBM-01) or Remote
Operator (TMC7-ROM-01).
Page 21
710-02887-00A
Trip/fault code
Initialised
Phase rotation
Reserved
Current (low byte)
Current (high byte)
Current %FLC (low byte)
Current %FLC (high byte)
Temperature
Reserved
Part Number: TMC7-ASM-01
Feature
0 = no trip
20 = motor overload
26 = current imbalance
50 = power circuit
54 = phase rotation
55 = supply frequency
75 = motor thermistor
101 = excess start time
113 = comms failure between interface and TMC7
114 = network comms failure
1 = phase rotation bit is valid (bit 1) after 1
1 = positive phase rotation detected
current (A)
current as a percentage of soft starter FLC setting (%)
motor temperature (%)
TMC7
ACCESSORIES
start
st
TMS7
TMC7 Series