Dell Alienware x17 R1 Service Manual page 27

● Always purchase genuine batteries from
Removing the battery cable
Prerequisites
1. Follow the procedure in
2. Remove the base cover.
3. Remove the battery.
About this task
NOTE: If the battery is disconnected from system board for service, then there is a delay during boot as the computer
undergoes RTC battery reset.
The following image(s) indicate the location of the battery cable and provides a visual representation of the removal procedure.
Steps
1. Turn the battery over.
2. Peel the battery cable off the battery.
3. Disconnect the battery cable from the battery.
4. Lift the battery cable off the battery.
Installing the battery cable
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the battery cable and provides a visual representation of the installation
procedure.
Before working inside your
www.dell.com or authorized Dell partners and resellers.
computer.
Removing and installing components 27