Description Of Each Menu; Wall Color; Aspect Ratio; Digital Zoom - BenQ MP512 ST User Manual

Description of each menu

FUNCTION
(default setting/
value)

Wall Color

(Off)

Aspect Ratio

(Auto)
Keystone
(0)
Position
(0)
Phase
(depends on the
selected input
signal)
H. Size
(0)

Digital Zoom

(1.0X)

Picture Mode

(PC source:
Dynamic;
Video source:
Standard)
Reference
Mode
(Dynamic)
Brightness
(50)
Contrast
(0)
Color
(0)
44 Operation
DESCRIPTION
(default setting/value)
Corrects the projected picture's color when the projection surface is
not white. See "Using Wall Color" on page 33
There are four options to set the image's aspect ratio depending on
your input signal source. See
details.
Corrects any keystoning of the image. See
page 30 for details.
Displays the position adjustment page. To move the projected image,
use the directional arrow keys. The values shown on the lower position
of the page change with every key press you made until they reach
their maximum or minimum.
Adjusts the clock phase to reduce image
distortion.
Adjusts the horizontal width of the image.
Magnifies or reduces the projected image. See
searching for details" on page 30
Pre-defined picture modes are provided so you can optimize your
projector image set-up to suit your program type. See
picture mode" on page 32
Selects a picture mode that most suits your need for the image quality
and further fine-tune the image based on the selections listed on the
same page below. See
details.
Adjusts the brightness of the image. See
page 33 for details.
Adjusts the degree of difference between dark and light in the image.
See "Adjusting Contrast" on page 33
Adjusts the color saturation level -- the amount of each color in a
video image. See "Adjusting Color" on page 34
"Selecting the aspect ratio" on page 31
"Correcting keystone" on
for details.
for details.
"Setting the User 1/User 2 mode" on page 33
"Adjusting Brightness" on
for details.
for details.
"Magnifying and
"Selecting a
for details.
for
for