Table of Contents
Advertisement
Description of each menu
Function
Wall Color
Aspect Ratio
Keystone
Position
Phase
H. Size
Digital Zoom
Picture Mode
Reference Mode
Brightness
Contrast
46
Operation
Corrects the projected picture's color when the projection
surface is not white. See
details.
There are four options to set the image's aspect ratio
depending on your input signal source. See
aspect ratio" on page 31
Corrects any keystoning of the image. See
keystone" on page 25
Displays the position adjustment page. To move the projected
image, use the directional arrow keys. The values shown on the
lower position of the page change with every key press you
made until they reach their maximum or minimum.
This function is only available when a PC signal (analog
RGB) is selected.
Adjusts the clock phase to reduce image
distortion.
This function is only available when a
PC signal (analog RGB) is selected.
Adjusts the horizontal width of the image.
This function is only available when a PC signal (analog
RGB) is selected.
Magnifies or reduces the projected image. See
searching for details" on page 31
Pre-defined picture modes are provided so you can optimize
your projector image set-up to suit your program type. See
"Selecting a picture mode" on page 33
Selects a picture mode that best suits your need for the image
quality and further fine-tune the image based on the selections
listed on the same page below. See
mode" on page 34
for details.
Adjusts the brightness of the image. See
on page 34
for details.
Adjusts the degree of difference between dark and light in the
image. See
"Adjusting Contrast" on page 34
Description
"Using Wall Color" on page 33
for details.
for details.
for details.
for details.
"Setting the User 1/User 2
"Adjusting Brightness"
for
"Selecting the
"Correcting
"Magnifying and
for details.
Advertisement
Table of Contents
