Table of Contents
Advertisement
Description of each menu
•
The default values listed in this manual, especially on pages 54-63, are
for reference only. They may vary between the projectors due to the
continuous improvement to the products.
1. DISPLAY menu
FUNCTION
Wall Color
Aspect Ratio
2D Keystone
Corner Fit
Position
Phase
H. Size
Digital Zoom
Digital Shrink
Operation
54
Corrects the projected picture's color when the projection surface is not
white. See
"Using Wall Color" on page 34
There are four options to set the image's aspect ratio depending on your
input signal source. See
details.
Corrects vertical and horizontal keystonings of the image. See
"Correcting 2D keystone" on page 24
Manually adjust four corners of the image by setting the horizontal and
vertical values. See
Displays the position adjusent page. To move the projected image, use
the directional arrow keys. The values shown on the lower position of
the page change with every key press you made until they reach their
maximum or minimum.
This function is only available when a PC signal (analog RGB) is
selected.
Adjusts the clock phase to reduce image distortion.
This function is only available when a PC
signal (analog RGB) is selected.
Adjusts the horizontal width of the image.
This function is only available when a PC signal (analog RGB) is
selected.
Magnifies the projected image. See
on page 31
for details.
Shrinks the image with middle point of the image fixed.
1.
Press MENU/EXIT and then press
is selected. Press
ENTER.
2.
Press
/
to reduce the image to a desired size.
DESCRIPTION
"Selecting the aspect ratio" on page 31
for details.
"Adjusting Corner Fit" on page 25
"Magnifying and searching for details"
to select Digital Shrink and press MODE/
for details.
for details.
/
until the DISPLAY menu
for
Advertisement
Table of Contents
