How Do I Use My Appliance And The Attachments?; Shaving - Philips S9000 Series Manual

How do I use my appliance and the attachments?

Shaving

2 Put the small plug in the charging stand and put
the supply unit in the wall socket.
3 Place the appliance in the charging stand.
Specific models only: The light ring on the bottom
of the charging stand lights up and rotates quickly.
- After approximately 5 minutes, the light ring
rotates slower. The battery now contains
enough energy for one full shave.
- As the appliance continues to charge, the light
ring becomes brighter and rotates slower.
- When the appliance is fully charged, the light
ring lights up fully and stops rotating.
Warning: Always check the appliance and all
accessories before use. Do not use the appliance
or any accessory if it is damaged, as this may
cause injury. Always replace a damaged part with
one of the original type.
You can use this appliance either wet or dry, or even
under the shower. For a wet shave, apply some water
and shaving foam or gel to your skin and rinse the
shaving heads under the tap with warm water before
following the steps below.
Switch on the appliance.
1
2 Move the shaving heads over your skin in circular
movements to catch all hairs growing in different
directions (see 'Main menu'). Make sure each
shaving head is fully in contact with the skin. Exert
gentle pressure for a close, comfortable shave.
Note: Do not press too hard, as this can cause skin
irritation. When you apply too much pressure, the
orange light ring lights up (see 'What is my shaver
telling me?').
17
English