High/Low Beam Switch; Automatic High Beam - If Equipped; Flash-To-Pass; Automatic Headlights - Dodge CHARGER 2021 Owner's Manual

If allowed by law in the country in which the

vehicle was purchased, the Daytime Running
Lights can be turned on and off using the
Uconnect system Ú page 140.
On some vehicles, the Daytime Running

Lights may deactivate, or reduce intensity, on
one side of the vehicle (when a turn signal is
activated on that side), or on both sides of
the vehicle (when the hazard warning lights
are activated).
H /L B S
IGH OW EAM WITCH
Push the multifunction lever toward the
instrument panel to switch the headlights to
high beams. Pulling the multifunction lever
back will turn the low beams on.
A H B — I
UTOMATIC IGH EAM
The Automatic High Beam Headlamp Control
system provides increased forward lighting at
night by automating high beam control through
the use of a digital camera mounted on the
inside rearview mirror. This camera detects
vehicle specific light and automatically switches
from high beams to low beams until the
approaching vehicle is out of view.
NOTE:
The Automatic High Beam Headlamp Control

can be turned on or off by selecting or dese-
lecting "Auto High Beam" within Uconnect
Settings Ú page 140, as well as turning the
headlight switch to the AUTO position.
Broken, muddy, or obstructed headlights and

taillights of vehicles in the field of view will
cause headlights to remain on longer (closer
to the vehicle). Also, dirt, film, and other
obstructions on the windshield or camera
lens will cause the system to function improp-
erly.
If the windshield or Automatic High Beam

Headlamp Control mirror is replaced, the
mirror must be re-aimed to ensure proper
E
F QUIPPED
performance. See a local authorized dealer.
F -T -P
LASH O
You can signal another vehicle with your
headlights by lightly pulling the multifunction
lever toward you. This will cause the high beam
headlights to turn on, and remain on, until the
lever is released.
ASS
GETTING TO KNOW YOUR VEHICLE
A H
UTOMATIC EADLIGHTS
This system automatically turns the headlights
on or off according to ambient light levels. To
turn the system on, rotate the headlight switch
counterclockwise to the AUTO position. When
the system is on, the headlight time delay
feature is also on. This means the headlights
will stay on for up to 90 seconds after placing
the ignition in the OFF position. The headlight
time delay can be programmed 0/30/60/90
seconds within Uconnect Settings Ú page 140.
To turn the automatic system off, move the
headlight switch out of the AUTO position.
NOTE:
The engine must be running before the head-
lights will come on in the automatic mode.
P L
ARKING IGHTS
To turn on the parking lights and instrument
panel lights, rotate the headlight switch
clockwise. To turn off the parking lights, rotate
the headlight switch back to the O (off) position.
NOTE:
For vehicles sold in Canada, rotate the head-
light switch to the AUTO position to turn off the

parking lights.

47
2