Miscellaneous Device; Button; Canadian/Gate Operator Programming - Dodge CHARGER 2021 Owner's Manual

44 GETTING TO KNOW YOUR VEHICLE
Non-Rolling Code Garage Door Opener Final
Steps
1. Push and hold the programmed
HomeLink® button and observe the
HomeLink® indicator light. If the
HomeLink® indicator light stays on
constantly, programming is complete.
2. Push the programmed HomeLink® button
to confirm that the garage door opener
motor operates. If the garage door opener
motor does not operate, repeat the steps
from the beginning.
WARNING!
Your motorized door or gate will open and

close while you are programming the
universal transceiver. Do not program the
transceiver if people or pets are in the path
of the door or gate.
Do not run your vehicle in a closed garage

or confined area while programming the
transceiver. Exhaust gas from your vehicle
contains Carbon Monoxide (CO) which is
odorless and colorless. Carbon Monoxide is
poisonous when inhaled and can cause you
and others to be severely injured or killed.
P H L
ROGRAMMING OME INK
M D
ISCELLANEOUS EVICE
Follow the procedure on programming
HomeLink® to a garage door opener
Ú page 43. Be sure to determine if the device
has a rolling code, or non-rolling code before
beginning the programming process.
NOTE:
Canadian radio frequency laws require trans-
mitter signals to time-out (or quit) after several
seconds of transmission, which may not be long
enough for HomeLink® to pick up the signal
during programming. Similar to this Canadian
law, some U.S. gate operators are designed to
time-out in the same manner. The procedure
may need to be performed multiple times to
successfully pair the device to your HomeLink®
buttons.
R A S
EPROGRAMMING INGLE
H L ® B
OME INK UTTON
To reprogram a single HomeLink® button that
has been previously trained, without erasing all
the channels, follow the procedure below.
® T A
Be sure to determine whether the new device
O
you want to program the HomeLink® button to
has a rolling code or non-rolling code.
1. Place the ignition in the ON/RUN position,
without starting the engine.
2. Push and hold the desired HomeLink®
button until the HomeLink® Indicator light
begins to flash after 20 seconds. Do not
release the button.
3. Without releasing the button, proceed with
Step 2 in "Programming HomeLink® To A
Garage Door Opener" and follow all
remaining steps.
C
ANADIAN
P
ROGRAMMING
For programming transmitters in Canada/
United States that require the transmitter
signals to "time-out" after several seconds of
transmission.
Canadian Radio Frequency (RF) laws require
transmitter signals to time-out (or quit) after
several seconds of transmission – which may
not be long enough for HomeLink® to pick up
the signal during programming.
/G O
ATE PERATOR