Set-Up Location Requirements; Electrical Connection; Inserting/Changing The Remote Control Batteries - Silvercrest SSTB 10 C2 Operating Instructions And Safety Instructions

Set-up location requirements

For safe and trouble-free operation of the device , the set-up location must fulfil the
following requirements:
■ Place the device on a firm, flat and level surface.
■ The surfaces of some items of furniture might contain components that can cor-
rode and soften the rubber feet of the device. If necessary, place a mat under the
device's rubber feet.
■ Do not operate the device in a hot, wet or extremely damp environment.
■ Keep a minimum distance of 30 cm to heat-emitting devices such as heaters,
ovens, etc.
■ Only operate the device in locations with adequate ventilation.
■ The mains socket must be easily accessible so that the plug can be easily pulled
out in an emergency.

Electrical connection

■ Before you connect the device, compare the connection data (voltage and fre-
quency) on the mains adapter type plate with that of the intended power source.
These data must agree so that no damage is sustained by the device.
■ Make sure that the mains adapter's connection cable is not damaged and is not
laying over hot surfaces and/or sharp edges.
■ Connect the plug of the connecting cable into the connector for the power sup-
ply on the rear of the unit and plug the mains adapter into a power outlet. Ensure
that the power cable is not stretched tightly or kinked.
■ Place the connecting cable such that no one can stumble over it.
■ Do not place the device, furniture or any other objects on the cable. Do not kink
the cable or knot it and do not connect it to other cables. Never wrap the cable
tightly around other objects otherwise the conductors inside the cable could
break and cause a malfunction.

Inserting/changing the remote control batteries

To insert/change the batteries, proceed as follows:
♦ Pull the cover off the battery compartment of the remote control.
♦ Remove any depleted batteries and insert two new type AAA/micro batteries into
the battery compartment. Be sure to insert the batteries with the correct polarity.
♦ Slide the cover back onto the battery compartment until it clicks into place.
■ 28 │ GB │ IE SSTB 10 C2