Table of Contents
Advertisement
HOW TO USE
THE APPLIANCE
FIRST TIME USE
If you plug in the washing machine, it will switch on
automatically . You will be asked to set the desired
language for the display .
Press the UP or DOWN key to select the desired
language, and confirm by pressing the OK key .
Afterwards you can adapt the water hardness
setting of your washing machine to your regional
water hardness . This is recommended in order
to optimize the Auto dosing function . Choose
between soft / medium / hard and confirm by
pressing the OK key .
Finally determine if you want to use Tank 2 of the
Auto dosing system for softener or detergent (refer
to sections AUTO DOSING) .
All settings which you do during the initial set-up
can be changed again later, if needed .
To remove any residues from the manufacturing
process:
1.
Select programme "Cotton" with temperature
95°C .
2.
Add a small amount of detergent to the
manual dosing compartment
dispenser (maximum 1/3 of the quantity the
detergent manufacturer recommends for lightly
soiled laundry) .
Deactivate the buttons for Auto dosing (Tank 1 and
Tank 2): press them so that the button light goes
off .
3.
Start the programme without adding any
laundry .
See section "DAILY USE" for more information on
how to select and start a programme .
AUTO DOSING FUNCTION
The detergent dispenser of the washing machine is
equipped with a two tanks system for the automatic
dispensing of liquid detergent and softener .
Before using this function, follow the instructions
in the USE AND CARE GUIDE/AUTO DOSING – FIRST
USE to:
1. Set the correct water hardness level
2. Set tank 2 content. By default, Tank 1 is set for a
detergent (your main detergent), and Tank 2 is set
for fabric softener . If you do not use fabric softener,
set Tank 2 for another detergent .
3. Check/adjust the preset dosing quantities.
By default, the system comes with the following
dosing values:
• 80 ml detergent for Tank 1
• 30 ml softener for Tank 2
You need to adjust these preset dosing values to
the dosing values reported on the detergent and
softener package that you intend to use .
After the Auto Dosing function is set for use, fill the
tanks with the appropriate content and install the
labels on the tanks accordingly, as explained in the
USE AND CARE GUIDE / AUTO DOSING – FIRST USE .
of the detergent
EN
13
Advertisement
Table of Contents
