Installation - Simu T5E-SP Hz Original Instructions Manual

These instructions apply to all T5E-SP Hz/T6E-SP Hz drive, the different versions of which are available in the current catalogue.
Field: The T5E-SP Hz/T6E-SP Hz drive are designed to drive all types of outdoor awnings with cassette. The installer, who
must be a motorisation and home automation professional, must ensure that the drive product is installed in accordance with the
standards in force in the country in which it is installed such as EN 13561 relating to outdoor screens and awnings.
Liability: Before installing and using the drive, please read operating and installation guide carefully. Please read
these instructions carefully before installing and using the drive. In addition to following the instructions given in this guide,
the instructions detailed in the attached Safety instructions document must also be observed. The drive must be installed by
a motorisation and home automation professional, according to instructions from SIMU and the regulations applicable in the
country in which it is commissioned. It is prohibited to use the drive outside the field of application described above. Such use, and
any failure to comply with the instructions given in this guide and in the attached Safety instructions document, absolves SIMU
of any liability and invalidates the warranty. The installer must inform its customers of the operating and maintenance conditions
for the drive and must provide them with the instructions for use and maintenance, and the attached Safety instructions
document, after installing the drive. Any After-Sales Service operation on the drive must be performed by a motorisation and
home automation professional. If in doubt when installing the drive, or to obtain additional information, contact a SIMU adviser
or go to the website www.simu.com.
1

Installation

Instructions which must be followed by the drive and home automation professional installing the drive:
- Methods of wiring are given by national standards or IEC 60364 standard.
- Cables which pass through a metal wall must be protected and isolated using a sheath or sleeve.
- T5E-SP Hz: The cable for the motor can be removed. If it is damaged, replace by the same. The cable may only be
connected to the motor by qualified personnel. The connector is to be assembled without damaging the contacts. The
continuity of the earth connection must be ensured.
- T6E-SP Hz: The cable for the motor cannot be removed. If it is damaged, return the drive to the After-Sales department.
Recommendations: Keep a minimum distance of 20 cm between two E-SP Hz motors. Keep a minimum distance of 30 cm
between E-SP Hz motors and Hz transmitters. A radio appliance using the same frequency (433,42 MHz) may deteriorate
our product's performance (ex. : hi-fi radio headphones).
Drilling the tube:
C
D
55
20
48*
4
* :35Nm max.
96
27,5
ø9
ø64
7,45
Mounting:
1
T5E-SP Hz / T6E-SP Hz
(230V~50Hz)
A
4xØB / 90°
L1
10/17 15/17
25/17 35/17
IP44
50/12
L2
L1
55/17 70/17
IP44
85/17 120/12
L2
5
2
3
.
Z.I. Les Giranaux - BP71 - 70103 Arc-Les-Gray CEDEX - FRANCE
Ø min.
47 583
47 657
60 713
Ø4,8 x 10
STEEL
Ø5 x 10
9910004
4
EN-Original instructions
5054093E
SIMU S.A.S. au capital de 5 000 000 €
RCS VESOUL B 425 650 090 - SIRET 425 650 090 00011
n° T.V.A CEE FR 87 425 650 090
mm
A ØB C D L1
5 26 4,2 596
5 26 4,2 670
5 36 8 728
i
-20°C / +60°C
L2
619
693
745
1/6